Subscribe to magazine

Macworld Forums: 10.2->10.2.8 failed until I installed 10.2.3 first - Macworld Forums

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

10.2->10.2.8 failed until I installed 10.2.3 first

#1 User is offline   Bob_Blaylock Icon

  • Member
  • PipPip
  • Group: Members
  • Posts: 111
  • Joined: 15-July 03

Posted 29 December 2003 - 05:55 PM

This relates to this thread, but since it's a different issue, I think it belongs in a different thread.

In rebuilding my beige G3 system, I found that once I had a working install of MacOS X 10.2, I could not successfully install the 10.2.8 Combo updater. It would run only so far, then it would tell me that an error had occurred, and to try again. I tried this repeatedly, both with my full 384 megabytes of RAM, and stripped down to only 128 megabytes.

After a while, I went back on Apple's site, and looked forthe oldest updater I could find that woudl update 10.2 to anything. I found the 10.2.3 Combo updater, and ran it. It installed just fine, after which I was able to successfully run the 10.2.8 Combo updater as well.

Are there any known issues that pertain to this?
0

#2 User is offline   Bob_Blaylock Icon

  • Member
  • PipPip
  • Group: Members
  • Posts: 111
  • Joined: 15-July 03

Posted 27 March 2004 - 02:42 PM

Updating my ROM from revision A to revision C corrected this problem as well. After that upgrade, I was able to install the 10.2.8 combo updater directly over 10.2.0.
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

2 User(s) are reading this topic
0 members, 2 guests, 0 anonymous users