[lister110]

I have a dps made in quark 6.1 (2 x 297+420) (but was originally converted from quark 4.1). The dps is 2 single pages as a spread. The problem I am getting is on the right hand page (pg2) when I put some boxes at x co-ordiantes at 0 the measurements reads at 297. But some keylines that run along the second page start at 0 on there left point? I have checked the preferences to see if it is seeing the measurements as single pages and this is right?? If I create a new document with spreads the the coordinates read correct on the right page...mmmm???
L I S T E R

[charlieartist]

Are the coordinates in the new document the same as in the old one? If the rulers had been moved, would this cause things to be out of alignment?
Hope this helps...

[lister110]

quark 6.1 seems to think certain boxes are starting at 297mm on the right page? but I have some other boxes starting at 0mm??? If I move the box which is at 297 to the right it starts counting from 0.1 upwards, if I then key in the measurements window 0 on the x co-ordiantes it returns to posistion but at 297...mmmm???? Is this a bug in quark from 4.1 to 6.1??