[mpertz]

I recently installed a fresh copy of Tiger on my emac and after using it for a bit it turned off by itself and won't turn on unless I plug and un-plug the power cord a few times. Once it does turn on it always just goes to the open firmware screen and if I type "mac-boot" the emac hangs. I replaced the logic board battery and reset the PMU and still does the same thing. I also reset the nvram and did a "reset all" command, but no matter what I do it always brings me back to the open firmware screen and won't go past that. Any ideas on what I can do to fix this would be really appreciated.